Technical information

Chapter 2: AT+i Commands Reference
May 31, 2008 AT+i Commands Reference Manual 2-107
+iFD - Restore All Parameters to Factory Defaults
PTD INT 0..65535 0 (No
Filter)
Specifies the number of Packets to Drop during a
SerialNET session.
Remote Firmware Update
UEN Byte 0..1 0 Remote Firmware Update flag.
Remote Parameter Update
RPG String 64 chars NULL Remote Parameter Update Group/Password.
Secure Socket Protocol (SSL3/TLS1)
CS Byte 0, 4, 5, 10,
47, 53
0
(propose
all)
Set the cipher suite to be used during SSL3/TLS
negotiations.
CA String 1300
chars
NULL Set W24's SSL3/TLS trusted Certificate Authority
(CA).
CERT String 4 Kbyte NULL Set W24's SSL3/TLS certificate.
PKEY String 4 Kbyte NULL Set W24's private key.
DHCP Server
DPSZ Byte 0-255 0
(DHCP
server off)
Set number of addresses in W24's IP pool.
DSLT INT 0-65535 0
(No limit)
Define lease time, in minutes, granted when
assigning IP addresses to clients.
iRouter Mode
ARS Byte 0..1 0 Causes W24 to automatically enter iRouter mode
upon power-up or soft reset.
Syntax: AT+iFD
Restore W24's non-volatile parameter database values to factory
defaults.
Each of W24's nonvolatile parameters, described in the following
section, has an associated default value. This command restores
all parameters to their factory default values.
This command disables W24's DHCP client. In order to
re-activate the DHCP client process, you need to perform a HW
or SW reset.
This command also resets W24's active IP address stored in the
IPA parameter.
An exception to the above are the MIS (Modem Init String), RPG
(Remote Parameter Group/Password) and CPF (Communications
Platform) parameters, which will always retain the last set value.
Table 2-6: Nonvolatile Parameter Database (Cont.)
Parameter Type Range Default Description