Technical information

May 31, 2008 AT+i Commands Reference Manual xiii
Preface
Manual Scope
This manual introduces the W24 AT+i commands, and describes how software developers can
use these commands to communicate with the W24 device, and to create software applications
that communicate with the W24 using these commands.
Note: The integrator should read the corresponding SW release notes for the W24 version he is
using to get information about differences from this manual.
Target Audience
This manual is intended for software developers who communicate with the W24 device using
the AT+i commands, and create applications to communicate with the W24 device using the AT+i
commands.
Manual Organization
This manual contains the following chapters:
• “Preface” provides a scope for this manual, document convention, safety instructions and a
liability notification.
• “Chapter 1: Introduction to AT+i Commands” gives an overview of the AT+i commands.
• “Chapter 2: AT+i Commands Reference” provides a reference to all available AT+i
commands, including examples, where relevant.
• “Appendix A: MIME Content Types and Subtypes” provides MIME content types and
subtypes.
• “Appendix B: Sample Parameter Update File” provides sample parameter update file.
• “Appendix C: NIST Time Servers” provides a list of NIST time servers.
• “Appendix D: Use Cases” provides some use cases.
Applicable Documents
• W24 Module Hardware Description – 6802984C95
• W24 Developer’s Kit – 6802985C05