Technical information

Chapter 2: AT+i Commands Reference
May 31, 2008 AT+i Commands Reference Manual 2-137
+iSMP - Define SMTP Login Password
+iPOP3 - Define POP3 Server Name
AT+iSMU=? Returns the message 'String'. The reply is followed by I/OK.
Syntax: AT+iSMP=pass
Permanently sets authenticated SMTP login.
Parameters: pass = Password to be used when logging on to an SMTP server
that requires authentication.
Command Options:
pass='' Empty: No SMTP authentication password defined.
pass=<password> password will be used to login to an authenticated SMTP server.
Default: Empty. No password defined.
Result Code:
I/OK If password is an empty or a legal SMTP login password.
I/ERROR Otherwise.
AT +i S MP ~pass Temporarily set the SMTP login password to pass. The
permanent value will be restored after completing the next
session, whether the session was successful or not.
AT+iSMP? Report the current SMTP login password. The reported value will
consist of '*' characters. The number of '*' characters shall reflect
the number of characters in the actual password. If a password
does not exist, only <CRLF> will be returned. The reply is
followed by I/OK.
AT+iSMP=? Returns the message 'String'. The reply is followed by I/OK.
Syntax: AT+iPOP3[p]=server
Permanently sets the POP3 Server Name or IP.
Parameters: server = a POP3 Server Name or IP address. The Server Name
must be resolvable by the primary or alternate DNS.
p = optional communication platform modifier for W24 Plus.
Where, p='S' to force the (serial) dial-up platform and p='L' to
force the LAN platform. p may be used to select any platform. If
p is omitted, the active platform will be used.
Command Options:
server="' Empty: No Server Name defined.