Technical information

Chapter 2: AT+i Commands Reference
May 31, 2008 AT+i Commands Reference Manual 2-139
+iMPWD - Define POP3 Mailbox Password
+iNTSn - Define Network Time Server
Syntax: AT+iMPWD=MBxPass
Permanently sets POP3 mailbox password.
Parameters: MBxPass = Mailbox password to be used for authentication,
when retrieving Email messages from the mailbox.
Command Options:
MBxPass ='' Empty: No mailbox password defined.
MBxPass =<mbox-pass> mbox-pass will be used to authenticate receiver, when retrieving
Email messages from the mailbox.
Default: Empty. No mailbox password defined. To retrieve Email
messages, the mailbox password must be defined ad-hoc.
Result Code:
I/OK If mbox-pass is an empty or legal mailbox password.
I/ERROR Otherwise.
AT+i MP WD ~ MbxPass Temporarily set the mailbox password to MBxPass. The
permanent password will be restored after completing the next
session, whether the session was successful or not.
AT+iMPWD? Report the current mailbox password. The reported value will
consist of '*' characters. The number of '*' characters shall reflect
the number of characters in the actual password. If a mailbox
password does not exist, only <CRLF> will be returned. The
reply is followed by I/OK.
AT+iMPWD=? Returns the message 'String'. The reply is followed by I/OK.
Syntax: AT+iNTSn=<server>
Sets the network time server name or IP.
Parameters: n = 1..2
server = A network timeserver name or IP address.
See “NIST Time Servers” for a list of NIST Time servers.
Command Options:
Server='' Empty. No Network Time Server defined.
Servrer=<nts> The server name or IP address, nts, will be used to retrieve the
current time-of-day - if the NTOD parameter is set to enable
time-of-day retrieval.
Current Time-of-Day will be returned in response to the RP8
command. Outgoing Email messages will be Time and Date
stamped.