Technical information

Chapter 2: AT+i Commands Reference
May 31, 2008 AT+i Commands Reference Manual 2-147
+iTOA - Define Primary Addressee
+iTO - Email 'To' Description/Name
I/ERROR Otherwise.
AT +i S BJ ~subject Temporarily set the contents of the 'Subject:' field of the next
Email to be sent. The permanent value will be restored after
completing the next session, whether the session was successful
or not.
AT+iSBJ? Report the current contents of the 'Subject:' parameter. If no
subject is defined, only <CRLF> will be returned. The reply is
followed by I/OK.
AT+iSBJ=? Returns the message 'String'. The reply is followed by I/OK.
Syntax: AT+iTOA[n]=Email@
Permanently sets Email addressee.
Parameters: Email@ = Email addressee. This is the default Email addressee,
which will be used to direct Email messages sent by W24.
n = optional index of addressee. When n is not specified, TOA00
(primary addressee) is used.
Command Options:
Email@='' Empty address: No addressee defined.
Email@=<addr> addr will be used as a destination address for future Email SEND
commands (+iEMA, +iEMB).
n= 01..50
Default: Empty. No addressee defined.
Result Code:
I/OK
AT+i TOA [n]~<add> Temporarily set the Email addressee to add. The permanent value
will be restored after completing the next session, whether the
session was successful or not.
AT +i TO A [n]? Report the current value of the Email addressee. If the addressee
does not exist, an empty line containing only <CRLF> will be
returned. The reply is followed by I/OK.
AT+i TOA [n]=? Returns the message 'String'. The reply is followed by I/OK.
Syntax: AT+iTO:to
Permanently sets Email header's 'To:' description.
Parameters: to = Contents of 'To:' description/name field.