Technical information

Chapter 2: AT+i Commands Reference
May 31, 2008 AT+i Commands Reference Manual 2-153
+iWPWD - Password for Application Website Authentication
Command Options:
string=" Empty. A default value of
"application/x-www-form-urlencoded"
will be used, and the server will expect the data to be the data sent
in a "Submit" of a form.
string=<Content-type> Type of file being sent by the AT+iSLNK command.
Default: Empty.
Result Code:
I/OK If string is empty or a legal string.
I/ERROR Otherwise.
Syntax: AT+iWPWD=Pass
Permanently sets the application website's remote parameter
update Password.
Parameters: Pass = Password to be used for authentication, when accepting
application Web site parameter updates from a remote Web
browser.
Command Options:
Pass=" Empty: Remote application Web site parameter updates over the
Web are effectively disabled.
Pass=<password> password will be used to restrict application Web site parameter
updates via a remote Web browser.
Pass="*" A password will not be required to authenticate application Web
site parameter updates via the Web, effectively unrestricting
remote parameter updates.
Default: Empty. No Password defined. Application Web site parameter
updates via a remote browser are fully restricted.
Result Code:
I/OK If pass is an empty or legal Password.
I/ERROR Otherwise.
AT+i WP WD ~pass Temporarily set the application Web site parameter Update
Password to pass. The permanent Password will be restored after
completing the next session, whether the session was successful
or not.
AT+iWPWD? Report the current Password. If a Password does not exist, only
<CRLF> will be returned. The reply is followed by I/OK.
AT+iWPWD=? Returns the message 'String'. The reply is followed by I/OK.