Technical information

Chapter 2: AT+i Commands Reference
May 31, 2008 AT+i Commands Reference Manual 2-157
+iIPA - Active IP Address
Note: When W24 is offline, the IP address is always 0.0.0.0.
+iIPG - IP Address of the Gateway
Default: Empty (0.0.0.0). No IPA defined. IP address will be resolved
through a DHCP server, if one is available.
Result Code:
I/OK If IP address is empty or a legal IP address.
I/ERROR Otherwise.
AT+iDIP? Report the current Default IP address. The reply is followed by
I/OK.
AT+iDIP=? Returns the message 'IP addr'. The reply is followed by I/OK.
Syntax: AT+iIPA=IP address
Changes the active IP to IP address.
Parameters: IP address = IP address.
Command Options:
IP address =<IP ADDR..> IP ADDR. will be assigned as the active W24 IP address.
Also changes the permanent Default IP address in nonvolatile
memory. See description of the DIP parameter. Valid only for
W24.
Default: Contents of the DIP parameter at power up.
Result Code:
I/OK If IP address is empty or a legal IP address.
I/ERROR Otherwise.
AT +i I PA ~IP address Temporarily set the current IP address. The permanent IP address
(stored in the DIP parameter) will be restored/resolved after
completing the next session, whether the session was successful
or not.
AT+iIPA? Report the current IP address.
AT+iIPA=? Returns the message 'IP addr.'. The reply is followed by I/OK.
Syntax: AT+iIPG=IP address
Permanently sets the IP address of the gateway to be used by
W24.
Parameters: IP address = Gateway IP address.