Technical information

Nonvolatile Parameter Database
2-168 AT+i Commands Reference Manual May 31, 2008
+iWSEC - Wireless LAN WPA Security
IP Registration Parameters
+iRRMA - IP Registration Mail Address
I/ERROR Otherwise.
AT+i WS Tn~sec Temporarily sets security type of the nth position to sec.
AT+i WS Tn? Reports the current security type value in position n. The reply is
followed by I/OK.
AT +i W ST n=? Returns the message '0-4'. The reply is followed by I/OK.
Syntax: AT+iWSEC=n
Sets the WPA protocol type to be used for wireless LAN security.
This parameter takes effect following either a hardware or
software reset (AT+iDOWN) only. A change to this parameter
during W24 operation does not affect the current connection.
Parameters:
n=0 WPA-TKIP protocol.
n=1 WPA2-AES protocol.
Default: 0
Result Code:
I/OK If n is within limits.
I/ERROR Otherwise.
AT+iWSEC? Reports the current value followed by I/OK.
AT+iWSEC=? Returns the message '0, 1'. The reply is followed by I/OK.
Syntax: AT+iRRMA= Email@
Permanently sets the IP registration addressee.
Parameters: Email@ = Email addressee. This addressee will receive a
registration Email message after W24 establishes an Internet
session connection as a result of an explicit AT+i command or as
a result of automated Internet session establishment procedures.
The Email will contain the W24's ID and dynamically assigned IP
address, in ASCII form. See Email IP Registration.
Command Options:
Email@=" Empty address: No Email will be sent after W24 goes online.