Technical information

Chapter 2: AT+i Commands Reference
May 31, 2008 AT+i Commands Reference Manual 2-193
iRouter Parameters
+iARS - Automatic Router Start
Syntax: AT+iARS=n
Causes W24 to automatically enter iRouter mode upon power-up
or soft reset.
Upon entering iRouter mode, W24 immediately goes online on the
dialup/cellular side. Packets are not buffered during dialup/cellular
connection establishment. After establishing the connection, W24
starts the routing service.
Parameters:
n=0 Do not start iRouter mode upon power-up or soft reset.
n=1 Enter iRouter mode upon power-up or soft reset.
Default: 0
Result Code:
I/OK If n is within limits.
I/ERROR Otherwise.
AT+iDSLT? Reports the current value. The reply is followed by I/OK.
AT+iDSLT=? Returns the message "0, 1". The reply is followed by I/OK.