Technical information

General AT+i Command Format
1-14 AT+i Commands Reference Manual May 31, 2008
111 Serial data overflow 112 Illegal command when modem
online
113 E-mail firmware update attempted
but not completed. The original
firmware remained intact
114 E-mail parameters update
rejected
115 SerialNET could not be started
due to missing parameters
116 Error parsing a new trusted CA
certificate
117 RESERVED 118 Protocol specified in the USRV
parameter does not exist or is
unknown
119 WPA passphrase too short - has to
be 8-63 chars
120 RESERVED
121 RESERVED 122 SerialNET error: Host
Interface undefined (HIF=0)
123 SerialNET mode error: Host baud
rate cannot be determined
124 SerialNET over TELNET
error: HIF parameter must be
set to 1 or 2
125 Invalid WEP Key 200 Socket does not exist
201 Socket empty on receive 202 Socket not in use
203 Socket down 204 No available sockets
206 PPP open failed for socket
207 Error creating socket 208 Socket send error
209 Socket receive error 210 PPP down for socket
212 Socket flush error
215 No carrier error on socket
operation
216 General exception
217 Out of memory 218 An STCP (Open Socket)
command specified a local port
number that is already in use
219 SSL initialization/internal CA
certificate loading error
220 SSL3 negotiation error
221 Illegal SSL socket handle. Must be
an open and active TCP socket.
222 Trusted CA certificate does not
exist
223 RESERVED 224 Decoding error on incoming
SSL data
225 No additional SSL sockets
available
226 Maximum SSL packet size (2K)
exceeded
227 AT+iSSND command failed
because size of stream sent
exceeded 2048 bytes
228
AT+iSSND command failed
because checksum calculated
does not match checksum sent
by host
Table 1-2: AT+i Result Code Summary (Cont.)
Response
String
Denotation