Technical information

SerialNET Mode Initiation
2-20 AT+i Commands Reference Manual May 31, 2008
Note: To terminate SerialNET mode, issue the ESC sequence (+++), power-cycle the W24 with
the MSEL signal pulled low for less than 5 seconds, or pull the MSEL signal low for more
than 5 seconds during runtime. After exiting SerialNET mode, W24 returns to normal
AT+i command mode.
I/ONLINE After successfully activating SerialNET mode. Allow a 2.5 seconds delay
for W24 re-initialization.
-or-
I/OFFLINE After successfully activating SerialNET Auto-Link mode (!) or Deferred
Connection mode.