Wi-Fi Module Developer's Guide

Support
54 Module Hardware Description May 31, 2008
• Software version of the unit (AT+i3 command) or model number
• PCB version (located on the PCB near the RF connector)
• Severity of the problem
• Problem description, including:
– Setup Configuration (such as Developer Board, handset, host, connections, and so on)
– Detailed scenario from startup
– Log of all the commands and the responses, beginning from startup
• Answers to the following questions:
– Was the same scenario tested on the Developer Board and the PC to reproduce the problem?
– How many units do you have, and how many of them have this problem?
– How often does the problem recur?
In addition to the information requested above, send the following AT commands and the
HyperTerminal log with the responses:
• AT+iRP10 // to get the signal strength (RX level)
• AT+iUID // to read the unit MSN number
• AT+i3 // to get the software version of the W24