user manual

3
32
The DSR-6000 displays warning messages for the following conditions:
• A warning message is displayed when the user changes from a MPEG program
number selection to a virtual channel.
Press any arrow button (
3456
) to back out of the field and leave it
unchanged. Otherwise, press the ENTER button to proceed.
• If the user selects a virtual channel that is not in the chosen VCT, then a
warning message, “Not in map” is displayed to the right of the virtual channel.
• Virtual channels identify satellite and polarity attributes. The RF input ports are
set up with satellite and polarity attributes. For more details, see "Port Menu"
on page 18. The DSR-6000 uses these satellite and polarity attributes to
determine which RF port to use. However, if the user selects a virtual channel
that does not match the satellite and polarity attributes of either port, then the
DSR-6000 is unable to determine which port to use and the following warning
message is displayed.
Press any arrow button (
3456
) to back out of the field and leave it unchanged.
Note: The DSR-6000 cannot decode the chosen virtual channel until a port is set
up with the applicable satellite and polarity information.
Xpndr Field
This non-editable field displays the current (Xpndr) transponder name (alpha/
numeric) that is downloaded. If the user selects a virtual channel that is not in the
chosen VCT, then a warning message, (Not in map) is displayed to the right of the
virtual channel. This field serves as a label or identifier for the signal source. For
more details, see "Port Menu" on page 18.
Press E to continue or to stop
CAUTION: Changing to DCII selection mode
E 00000 0000 (Not in map)
CHANNEL VCT Channel Xpndr
Press E to continue or to stop
CAUTION: Channel dddd not present