Specifications

INTERFACE-RADIO COMMANDS 23 - 43
23.1.30 sniffer-redirect
 interface-radio Instance
Captures and redirects packets to an IP address running a packet capture/analysis tool
Supported in the following platforms:
• Wireless Controller — RFS4011
Syntax
sniffer-redirect [omnipeek|tzsp] <IP> channel [1|1+|10|10-|100--------165]
Parameters
• sniffer-redirect [omnipeek|tzsp] <IP> channel [1|1+|10|10---------165]
Examples
RFS4000-880DA7(config-profile-default_RFS4000-if-radio1)#sniffer-redirect omnipeek
172.16.10.1 channel 1
RFS4000-880DA7(config-profile-default_RFS4000-if-radio1)#show context
interface radio1
rf-mode sensor
placement outdoor
mesh preferred-peer 2 11-22-33-44-55-66
beacon period 50
rts-threshold 100
off-channel-scan channel-list 2.4GHz 1
aggregation ampdu tx-only
rifs tx-only
sniffer-redirect omnipeek 172.16.10.1 channel 1
aeroscout mac 11-22-33-44-55-66
non-unicast tx-rate bss 1 dynamic-all
non-unicast tx-rate bss 2 highest-basic
non-unicast tx-rate bss 3 highest-basic
--More--
Related Commands
sniffer-redirect Captures and redirects packets to an IP address running a packet capture/analysis tool
omnipeek Encapsulates captured packets in proprietary header (use with OmniPeek and plug-in)
tzsp Encapsulates captured packets in TZSP (use with WireShark and other tools)
<IP> Specify the IP address of the device running the capture/analysis tool
[1|1+|10|10-|100|----------
165]
Specify the channel to capture packets
• 1 – Channel 1 in 20Mhz
• 1+ – Channel 1 as primary, Channel 5 as extension
• 10 – Channel 10 in 20Mhz
• 10- – Channel 10 as primary, Channel 6 as extension
• 100 – Channel 100 in 20Mhz
no Disables capture and redirection of packets