Specifications

ManualsBrandsMotorola ManualsSoftwareWiNG 5.2.6

1101

A - 8 WiNG 5.2.6 Wireless Controller CLI Reference Guide

RFS4000(config-profile-AP7131_UseCase1)#interface radio 1

RFS4000(config-profile-AP7131_UseCase1-if-radio1)#wlan 1

RFS4000(config-profile-AP7131_UseCase1-if-radio1)#exit

RFS4000(config-profile-AP7131_UseCase1)#interface radio 2

RFS4000(config-profile-AP7131_UseCase1-if-radio2)#wlan 1

RFS4000(config-profile-AP7131_UseCase1-if-radio2)#exit

RFS4000(config-profile-AP7131_UseCase1)#

Commit the changes made to the profile and exit this context.

RFS4000(config-profile-AP7131_UseCase1)#commit write

RFS4000(config-profile-AP7131_UseCase1)#exit

RFS4000(config)#

Apply this Profile to the Discovered AP7131

Access the discovered access point using the following command. The discovered device’s MAC address is used to access

its context.

RFS4000(config)#AP7131 00-23-68-16-C6-C4

RFS4000(config-device-00-23-68-16-C6-C4)#

Assign the AP profile to this access point.

RFS4000(config-device-00-23-68-16-C6-C4)#use profile AP7131_UseCase1

RFS4000(config-device-00-23-68-16-C6-C4)#commit write

Apply the RF Domain profile to the AP

Apply the previously created RF Domain to enable a country code to be assigned to the discovered access point. A

discovered access point only works properly if its country code is the same as its associated wireless controller.

RFS4000(config-device-00-23-68-16-C6-C4)#use rf-domain RFDOMAIN_UseCase1

RFS4000(config-device-00-23-68-16-C6-C4)#commit write

RFS4000(config-device-00-23-68-16-C6-C4)#Exit

RFS4000(config)#

A.1.3.5 Creating a DHCP Server Policy



Using the Command Line Interface to Configure the WLAN

The DHCP server policy defines the parameters required to run a DHCP server on the wireless controller and assign IP

addresses automatically to devices that associate. Configuring DHCP enables the reuse of a limited set of IP addresses.

To create a DHCP server policy:

RFS4000(config)#dhcp-server-policy DHCP_POLICY_UseCase1

RFS4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1)#

Table A.1 displays how IP addresses are used.

Table A.1 IP Address Usage

IP Range Usage

172.16.11.1 till 172.16.11.10 Reserved for devices that require a static IP address

172.16.11.11 till 172.16.11.200 Range of IP addresses that can be assigned using the DHCP

server.

172.16.11.201 till 172.16.11.254 Reserved for devices that require a static IP address