Specifications

A - 9
In the table, the IP address range of 172.16.11.11 to 172.16.11.200 is available using the DHCP server. To configure the
DHCP server:
RFS4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1)#dhcp-pool
DHCP_POOL_USECASE1_01
RFS4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-
DHCP_POOL_USECASE1_01)#
Configure the address range as follows:
RFS4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-
DHCP_POOL_USECASE1_01)#address range 172.16.11.11 172.16.11.200
RFS4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-
DHCP_POOL_USECASE1_01)#
Configure the IP pool used with a network segment. This starts the DHCP server on the specified interface.
RFS4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-
DHCP_POOL_USECASE1_01)#network 172.16.11.0/24
RFS4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-
DHCP_POOL_USECASE1_01)#exit
RFS4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1)#exit
RFS4000-37FABE(config)#commit write
Configure the RFS4000 to use the DHCP Policy
For the DHCP to work properly, the new DHCP Server Policy must be applied to the wireless controller. To apply the DHCP
Server Policy to the wireless controller:
RFS4000-37FABE(config)#self
0A_WiNG_5_2_WC_CLI_Appendix.fm-37FABE(config-device-03-14-28-57-14-28)#use dhcp-
server-policy DHCP_POLICY_UseCase1
RFS4000-37FABE(config-device-03-14-28-57-14-28)#commit write
RFS4000-37FABE(config-device-03-14-28-57-14-28)#exit
RFS4000-37FABE(config)#
A.1.3.6 Completing and Testing the Configuration
 Using the Command Line Interface to Configure the WLAN
A wireless client must be configured to associate with the wireless controller managed WLAN. The following information
must be defined:
•SSID:
WLAN_USECASE_01
• Country: Same as the country configured in Creating a RF Domain on page A-4. In this scenario, the country code is set
to US.
• Mode: Infrastructure
With the WLAN set to beacon, use the wireless client’s discovery client to discover the configured WLAN and associate.