Specifications

4 - 46 WiNG 5.2.6 Wireless Controller CLI Reference Guide
4.1.18 customize
 global config mode commands
Customizes the output of the summary CLI commands. Use this command to define the data displayed as a result of various
show commands.
Supported in the following platforms:
• Access Points — AP300, AP621, AP622, AP650, AP6511, AP6521, AP6532, AP71XX, AP81XX
• Wireless Controllers — RFS4000, RFS6000, RFS7000, NX9000, NX9500
Syntax
customize [hostname-column-width|show-wireless-client|show-wireless-client-stats|
show-wireless-client-stats-rf|show-wireless-radio|show-wireless-radio-stats|
show-wireless-radio-stats-rf]
customize hostname-column-width <1-64>
customize show-wireless-client (ap-name <1-64>,auth,bss,enc,hostname <1-64>,ip,
last-active,location <1-64>,mac,radio-alias <3-67>,radio-id,radio-type,state,
username <1-64>,vendor,vlan,wlan)
customize show-wireless-client-stats (hostname <1-64>,mac,rx-bytes,rx-errors,
rx-packets,rx-throughput,tx-bytes,tx-dropped,tx-packets,tx-throughput)
customize show-wireless-client-stats-rf (average-retry-number,error-rate,
hostname <1-64>,mac,noise,q-index,rx-rate,signal,snr,t-index,tx-rate)
customize show-wireless-radio (adopt-to,ap-name <1-64>,channel,location <1-64>,
num-clients,power,radio-alias <3-67>,radio-id,radio-mac,rf-mode,state)
customize show-wireless-radio-stats (radio-alias <3-67>,radio-id,radio-mac,
rx-bytes,rx-errors,rx-packets,rx-throughput,tx-bytes,tx-dropped,tx-packets,
tx-throughput)
customize show-wireless-radio-stats-rf (average-retry-number,error-rate,noise,
q-index,radio-alias <3-67>,radio-id,radio-mac,rx-rate,signal,snr,t-index,
tx-rate)
Parameters
• customize hostname-column-width <1-64>
• customize show-wireless-client (ap-name <1-64>,auth,bss,enc,hostname <1-64>,ip,
last-active,location <1-64>,mac,radio-alias <3-67>,radio-id,radio-type,state,
username <1-64>,vendor,vlan,wlan)
hostname-column-width
<1-64>
Configures the default width of the hostname column in all show commands
• <1-64> – Specify the hostname column width from 1 - 64 characters.
show-wireless-client Customizes the columns displayed for the show wireless client command
ap-name <1-64> Includes the ap-name column in the show wireless client command.
• <1-64> – Specify the ap-name column width from 1 - 64 characters.
auth Includes the auth column in the show wireless client command. The auth column displays
the authorization protocol used by the wireless client.
bss Includes the BSS column in the show wireless client command. The BSS column displays
the BSSID the wireless client is associated with.
enc Includes the enc column in the show wireless client command. The enc column displays the
encryption suite used by the wireless client.