Specifications

4 - 154 WiNG 5.2.6 Wireless Controller CLI Reference Guide
4.1.49.2.2 acl
 wlan-mode-commands
Defines the actions taken based on an ACL rule configuration
Supported in the following platforms:
• Access Points — AP300, AP621, AP622, AP650, AP6511, AP6521, AP6532, AP71XX, AP81XX
• Wireless Controllers — RFS4000, RFS6000, RFS7000, NX9000, NX9500
Syntax
acl exceed-rate wireless-client-denied-traffic <0-1000000> {blacklist|disassociate}
acl exceed-rate wireless-client-denied-traffic <0-1000000> {blacklist <0-86400>|
disassociate}
Parameters
• acl exceed-rate wireless-client-denied-traffic <0-1000000> {blacklist <0-86400>|
disassociate}
Examples
rfs7000-37FABE(config-wlan-wlan1)#acl exceed-rate wireless-client-denied-traffic
20 disassociate
rfs7000-37FABE(config-wlan-wlan1)#show context
wlan wlan1
ssid wlan1
bridging-mode tunnel
encryption-type none
authentication-type none
802.11w sa-query timeout 110
802.11w sa-query attempts 1
accounting syslog host 172.16.10.12 port 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
rfs7000-37FABE(config-wlan-wlan1)#
acl exceed-rate Sets the actions taken based on an ACL rule configuration (for example, drop a packet)
• exceed-rate – Action is taken when the rate exceeds a specified value
wireless-client-denied-
traffic <0-1000000>
Sets the action to deny traffic to the wireless client, when the rate exceeds the specified
value
• <0-1000000> – Specify a allowed rate threshold of disallowed traffic in packets/sec.
blacklist <0-86400> Optional. When enabled, sets the time interval to blacklist a wireless client
disassociate Optional. When enabled, disassociates a wireless client