Specifications

1 - 10 WiNG 5.2.6 Wireless Controller CLI Reference Guide
1.4.4 Creating Profiles
Profiles are sort of a ‘template’ representation of configuration. The system has:
• a default wireless controller profile
• a default profile for each of the following access points:
• AP621, AP622, AP650, AP6511, AP6521, AP6532, AP71XX, AP81XX
To modify the default profile to assign an IP address to the management port:
rfs7000-37FABE(config)#profile rfs7000 default-rfs-7000
rfs7000-37FABE(config-profile-default-rfs-7000)#interface me1
rfs7000-37FABE(config-profile-default-rfs-7000-if-me1)#ip address 172.16.10.2/24
rfs7000-37FABE(config-profile-default-rfs-7000-if-me1)#commit
rfs7000-37FABE(config-profile-default-rfs-7000)#exit
rfs7000-37FABE(config)#
The following command displays default ap7131 profile:
rfs7000-37FABE(config)#profile ap7131 default-ap7131
rfs7000-37FABE(config-profile-default-ap7131)#show context
1.4.5 Change Default Profile by creating VLAN 150 and Mapping to ge3 Physical Interface
Logon to the wireless controller in config mode and follow the procedure below:
rfs7000-37FABE(config-profile-default-rfs7000)# interface vlan 150
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan150)# ip address
192.168.150.20/24
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan150)# exit
rfs7000-37FABE(config-profile-default-rfs7000)# interface ge 3
rfs7000-37FABE(config-profile-default-rfs7000-if-ge3)# switchport access vlan 150
rfs7000-37FABE(config-profile-default-rfs7000-if-ge3)# commit write
[OK]
rfs7000-37FABE(config-profile-default-rfs7000-if-ge3)# show interface vlan 150
Interface vlan150 is UP
Hardware-type: vlan, Mode: Layer 3, Address: 00-15-70-37-FA-BE
Index: 8, Metric: 1, MTU: 1500
IP-Address: 192.168.150.20/24
input packets 43, bytes 12828, dropped 0, multicast packets 0
input errors 0, length 0, overrun 0, CRC 0, frame 0, fifo 0, missed 0
output packets 0, bytes 0, dropped 0
output errors 0, aborted 0, carrier 0, fifo 0, heartbeat 0, window 0
collisions 0
1.4.5.1 Viewing Configured APs
To view previously configured APs, enter the following command:
rfs6000-380649(config)#show wireless ap configured
------------------------------------------------------------------------------------
IDX NAME MAC PROFILE RF-DOMAIN ADOPTED-BY
------------------------------------------------------------------------------------
1 ap650-3116B5 00-23-68-31-16-B5 default-ap650 default un-adopted
------------------------------------------------------------------------------------
rfs6000-380649(config)#