Specifications

7 - 64 WiNG 5.2.6 Wireless Controller CLI Reference Guide
7.1.20.1 address
 nat-pool
Configures NAT pool IP addresses
Supported in the following platforms:
• Access Points — AP300, AP621, AP622, AP650, AP6511, AP6521, AP6532, AP71XX, AP81XX
• Wireless Controllers — RFS4000, RFS6000, RFS7000, NX9000, NX9500
Syntax
address [<IP>|range]
address range <START-IP> <END-IP>
Parameters
• address [<IP>|range <START-IP> <END-IP>]
Examples
rfs7000-37FABE(config-profile-default-RFS7000-nat-pool-pool1)#address range 172.
16.10.2 172.16.10.8
rfs7000-37FABEconfig-profile-default-RFS7000-nat-pool-pool1)#show context
ip nat pool pool1
address range 172.16.10.2 172.16.10.8
rfs7000-37FABE(config-profile-default-RFS7000-nat-pool-pool1)#
Related Commands
address <IP> Adds a single IP address to the NAT pool
range <START-IP>
<END-IP>
Adds multiple IP (a range of IP addresses) addresses to the NAT pool
• <START-IP> – Specify the starting IP address of the range.
• <END-IP> – Specify the ending IP address of the range.
no Disables NAT pool IP addresses