Specifications

USER EXEC MODE COMMANDS 2 - 15
2.1.7 create-cluster
 user exec mode commands
Creates a new cluster on a specified device
Supported in the following platforms:
• Access Points — AP300, AP621, AP622, AP650, AP6511, AP6521, AP6532, AP71XX, AP81XX
• Wireless Controllers — RFS4000, RFS6000, RFS7000, NX9000, NX9500
Syntax
create-cluster name <CLUSTER-NAME> ip <IP> {level [1|2]}
Parameters
• create-cluster name <CLUSTER-NAME> ip <IP> {level [1|2]}
Examples
rfs7000-37FABE>create-cluster name Cluster1 ip 172.16.10.1 level 1
... creating cluster
... committing the changes
... saving the changes
[OK]
rfs7000-37FABE>
Related Commands
create-cluster Creates a cluster
name
<CLUSTER-NAME>
Configures the cluster name
• <CLUSTER-NAME> – Specify a cluster name
ip <IP> Specifies the device’s IP address to create cluster on
• <IP> – Specify the device’s IP address in A.B.C.D format
level [1|2] Optional. Configures the routing level for this cluster
• 1 – Configures level 1 (local) routing
• 2 – Configures level 2 (inter-site) routing
cluster Initiates cluster context. The cluster context provides centralized management to configure
all cluster members from any one member.
join-cluster Adds a wireless controller, as a member, to an existing cluster of wireless controllers