Specifications

20 - 2 WiNG 5.2.6 Wireless Controller CLI Reference Guide
20.1 smart-rf-policy
Table 20.1summarizes Smart RF policy configuration commands.
Table 20.1 smart-rf policy commands
Command Description Reference
assignable-power Specifies the power range during power assignment page 20-3
channel-list Assigns the channel list for the selected frequency page 20-4
channel-width Selects the channel width for Smart RF configuration page 20-5
coverage-hole-
recovery
Enables recovery from errors page 20-6
enable Enables a Smart RF policy page 20-8
group-by Configures grouping parameters page 20-9
interference-
recovery
Recovers issues due to excessive noise and interference page 20-10
neighbor-recovery Enables recovery from errors due to faulty neighbor radios page 20-12
no Negates a command or sets its default values page 20-14
sensitivity Configures Smart RF sensitivity page 20-16
smart-ocs-
monitoring
Applies smart off channel scanning instead of dedicated detectors page 20-17
smart-ocs-
monitoring
(ap7161)
Enables automatic channel selection on an AP7161 device. page 20-20
clrscr Clears the display screen page 5-3
commit Commits (saves) changes made in the current session page 5-4
do Runs commands from EXEC mode page 4-67
end Ends and exits the current mode and moves to the PRIV EXEC mode page 5-5
exit Ends the current mode and moves to the previous mode page 5-6
help Displays the interactive help system page 5-7
revert Reverts changes to their last saved configuration page 5-13
service Invokes service commands to troubleshoot or debug
(config-if)
instance configurations
page 5-14
show Displays running system information page 6-4
write Writes the system running configuration to memory or terminal page 5-40