Wireless Broadband Routers User Guide

Section 1 Overview
1-8 WR850
LED Description
LED Condition Color Status
1 Power
ON Green The device is powered on and operating normally.
ON Red The Power LED turns RED as soon as the reset
button is depressed. If the reset button is held
down, the LED starts to blink RED and the
router’s username, password, private LAN IP
address, private subnet mask address and
operation mode are restored to factory default
settings.
If the Power LED stays RED for longer than 5
seconds, this indicates that the firmware is
corrupted and needs to be restored.
OFF None The device is not powered on.
2 Modem
ON/
Blinking Amber 10BaseT link detected / active traffic present.
ON/
Blinking Green 100BaseT link detected / active traffic present.
OFF None No external Ethernet device has been attached
and detected. The Ethernet link may be down.
3 Wireless
ON/
Blinking Green The wireless interface is enabled / active traffic
present.
NOTE: The wireless LED does not blink on WR850G
“Version 1” hardware. You can determine
your version of hardware by looking at the
product label on the bottom of the router.
Within the box that includes the FCC logo, a
“Version 1” unit will display “MODEL:
WR850G”, while a “Version 2” unit will display
“MODEL: WR850Gv2” (see example below).
INPUT VOLTAGE: + 5VDC, 2A
FCC ID: F2N WR 850G
FOR HOME OR OFFICE USE
Te st e d To C om pl y
With FCC Standards
MODE L: WR8 50G
WIRELESS MAC: AB CD EF 01 23 45
WAN MAC: AB CD EF 01 23 45
MADE IN TAIWAN
MODEL WR850G
PART NUMBER: AAAAAA-BBB-CC
S/N: PPPPMMYJJJSSSSSCAABBCCCC
OFF None The wireless interface is not enabled by the
firmware.
4 LAN (x4)
ON/
Blinking
Amber 10BaseT link detected / active traffic present
.
ON/
Blinking
Green 100BaseT link detected / active traffic present
.
OFF None No external Ethernet device has been attached
and detected. The Ethernet link may be down.