Wireless Broadband Routers User Guide

Configuration Section 3
WR850 3-21
Field Description
PPPoE Access
Concentrator:
(ADVANCED)
Sets the name of the PPP access concentrator, as may be required
by some ISPs.
FACTORY DEFAULT: (blank)
PPPoE Connect
on Demand:
(ADVANCED)
Sets whether the PPP connection should be automatically
disconnected if no traffic has been observed for the period specified
by PPPoE Max Idle Time.
• Selecting Enabled engages this automatic disconnection.
• Selecting Disabled suppresses automatic disconnection.
FACTORY DEFAULT: Disabled
PPPoE Max Idle
Time:
(ADVANCED)
Sets the number of seconds to wait before disconnecting the PPPoE
connection if PPPoE Connect on Demand is Enabled.
This value can be anywhere between 1 and 3600 seconds.
FACTORY DEFAULT: 60
PPPoE Keep
Alive:
(ADVANCED)
Sets whether or not the PPPoE connection should be automatically
restored if it is lost.
• Selecting Enabled automatically restores lost connections.
• Selecting Disabled suppresses automatic re-connection.
NOTE: This setting has no effect unless PPPoE Connect on Demand
(above) is Disabled.
FACTORY DEFAULT: Disabled
PPPoE MRU:
(ADVANCED)
Sets the maximum number of bytes that the PPPoE connection will
receive in a single Ethernet frame.
This value can be anywhere between 128 and 9999 bytes.
FACTORY DEFAULT: 1492
PPPoE MTU:
(ADVANCED)
Sets the maximum number of bytes that the PPPoE connection will
transmit in a single Ethernet frame.
This value can be anywhere between 128 and 9999 bytes.
FACTORY DEFAULT: 1492