Wearable Terminal User Guide

Accessories 3 - 7
RS409 Scanner
To connect the RS409 scanner to the wearable terminal:
1. Remove the rubber plug from the wearable terminal interface connector.
2. Connect the RS409 interface cable to the wearable terminal interface connector. If the wearable terminal is
mounted on the arm, connect the cable to the interface connector closest to the wrist.
Figure 3-4 Connecting RS409 to Wearable Terminal
3. If using the extended cable configuration, route the scanner cable up to the shoulder and down to the hand that
the scanner mounts on. Attach two cable clips to clothing and secure cable to cable clip.
Figure 3-5 Cable Clip Installation
4. Rotate the trigger assembly to the correct position for the hand that the scanner mounts to.
NOTE There are two RS409 configurations available. The short cable configuration connects the RS409 to the
wearable terminal mounted on the arm. The extended cable configuration connects the RS409 to the WT4090
mounted on the hip.
Scanner Cable Connector
Interface Connector