Wearable Terminal User Guide

4 - 6 WT4090 Wearable Terminal User Guide
Four Slot Ethernet Cradle
Table 4-2 Troubleshooting the Four Slot Ethernet Cradle
Problem Cause Solution
Wearable terminal amber
Charge Status LED does not
light when
wearable terminal
inserted.
Cradle is not receiving power. Ensure the power cable is connected
securely to both the cradle and to AC power.
Wearable terminal is not
correctly seated.
Remove and re-insert the
wearable terminal
into the cradle, ensuring it is correctly seated.
Wearable terminal battery is
not charging.
Wearable terminal was
removed from cradle or cradle
was unplugged from AC power
too soon.
Ensure cradle is receiving power. Ensure the
wearable terminal is seated correctly. If the
wearable terminal battery is fully depleted, it
can take up to four hours to fully recharge a
Standard Battery and it can take up to six
hours to fully recharge an Extended Life
Battery.
Battery is faulty. Verify that other batteries charge properly. If
so, replace the faulty battery.
The
wearable terminal is not
fully seated in the cradle.
Remove and re-insert the wearable terminal
into the cradle, ensuring it is correctly seated.
During data communication,
no data was transmitted, or
transmitted data was
incomplete.
Wearable terminal removed
from cradle during
communication.
Replace
wearable terminal in cradle and
retransmit.
Incorrect cable configuration. See the system administrator or refer to the
WT4090 Integrator Guide.
Ethernet connection error. Link
LED is not lit (see
Link LED on
page 3-5
).
See the system administrator. Probable
Ethernet connection error.
Wearable terminal’s main
batteries not charging.
Ambient temperature of the
cradle is too warm or too cold.
Move the cradle to an area where the
ambient temperature is between 0 °C and 40
°C (32 °F and 104 °F).