Instructions
Table Of Contents
- 1. Safety Instructions and Responsibility
- 2. Compatibility Hint
- 3. Introduction
- 4. Electrical Connections
- 5. Parameter / Overview-Menu Structure
- 5.1. General Menu
- 5.2. Mode Frequency
- 5.3. Mode Counter
- 5.4. Mode SSI
- 5.5. Mode Start/Stop
- 5.6. Preselection Values
- 5.7. Preselection 1 Menu
- 5.8. Preselection 2 Menu
- 5.9. Preselection 3 Menu
- 5.10. Preselection 4 Menu
- 5.11. Preselection 5 Menu
- 5.12. Preselection 6 Menu
- 5.13. Serial Menu
- 5.14. Analog Menu
- 5.15. Command Menu
- 5.16. Linearization Menu
- 6. Appendix
9085_5010_04a_oi_e.docx / Feb-21 page 18 / 72
Analog output (X4)
A 16 bit analog output is available at terminal X4 pin 1, 2 and 3.
This output can be configured and scaled in the ANALOG MENU.
The following configuration is possible:
• Voltage output: -10 … +10 V
• Current output: 0 … 20 mA
• Current output: 4 … 20 mA
The analog output is proportional to the display value and is referenced to potential AGND.
AGND and GND are internally interconnected.
Important:
A parallel operation with voltage and current output at the analog output is not allowed.