Instructions

9085_5010_04a_oi_e.docx / Feb-21 page 70 / 72
Continuation “Operating modes / OP modes of the Start/Stop interface”
• SPEED (speed measurement)
The speed is recorded and can be converted again into another unit using existing scaling parameters
(Factor, Divider and Additive Value), if desired.
Interpretation of the measurement result during speed measurement:
The default setting ("FACTOR = 1", "DIVIDER = 1" and "ADDITIVE VALUE = 0") corresponds to a
velocity output in meters per second [m/s].
The analog output, the setpoints of the transistor outputs and the linearization
function always refer to the scaled measuring result of the selected operational
mode!