User manual

AX34509b_e.doc / Feb-13 Page 26 / 38
6.5.2. Operational Parameters for configuration of the interface:
Menu
Setting Range
Default
Serial Timer:
Setting 0,000 allows manual activation of a serial data
transmission at any time. All other settings specify the cycle
time for automatic transmission, when the interface is set to
"Printer Mode"
0,000
0,010 sec
…
9.999 sec
0,100 sec
Between two transmission cycles the unit will allow a pause
depending on the baud rate. The minimum cycle times for
timer transmissions are shown in the table.
Baud Rate Minimum Cycle Time [ms]
600 384
1200 192
2400 96
4800 48
9600 24
19200 12
38400 6
Serial Mode:
PC: Operation according to communication profile
(see 6.5.3)
Print1: Transmission of string type 1 (see 6.5.4)
Print2: Transmission of string type 2 (see 6.5.4)
Serial Register-Code:
100
...
120
101
Specifies the register code of the data to be transmitted.
The most important register codes are:
Register S-Code ASCII
Actual display value 101 :1
Analogue input A *) 106 :6
Analogue input B *) 107 :7
Display channel A 113 ;3
Display channel B 114 ;4
Display channel [A,B] combined 115 ;5
*) Normalized analogue input values, scaling 0 ... 10 000 for 0% to 100% of full scale input signal