User manual

Dx34510b_oi_e.doc / Jun-15 Page 12 / 42
3.2. Selection and Setting of Parameters
3.2.3. How to select a parameter
The ENTER key will scroll through the menu. The SET key allows to select the corresponding item
and to change the setting or the numeric value. After this, the selection can be stored by ENTER
again, which automatically changes over to the next menu item.
3.2.4. How to change parameter settings
With numerical entries, at first the lowest digit will blink. When keeping the SET key continuously
down, the highlighted digit will scroll in a continuous loop from 0 … 9 , 0 … 9. After releasing
the SET key, the actual value will remain and the next digit will be highlighted (blink). This
procedure allows setting of all digits to the desired values. After the most significant digit has
been set, the low order digit will blink again and you can do corrections if necessary.
With signed parameters, the high order digit will scroll from “0” to "9" (positive) followed by
“-“ and "-1" (negative)
3.2.5. How to store settings
To store the actual setting, press the ENTER key, which will also automatically scroll forward the
menu.
At any time the unit changes from programming mode to normal display operation, when you
keep the ENTER key down again for at least 3 seconds.
3.2.6. Time-Out Function
A “time-out” function will automatically conclude every menu level, when for a break period of 10
seconds no key has been touched. In this case, all changes which have not been confirmed by
ENTER yet would remain unconsidered.