User manual

Dx34510b_oi_e.doc / Jun-15 Page 14 / 42

4. The Operator Menu

The menu provides one section with “Basic Parameters” and another section with “Operational

Parameters”. On the display you will only find those parameters which have been enabled by the

basic settings. E.g. when the Linearisation Function has been disabled in the basic set-up, the

associated linearization parameters will also not appear in the parameter menu.

All parameters, as good as possible, are designated by text fragments. Even though the

possibilities of forming texts are very limited with a 7-segment display, this method has proved to

be most suitable for simplification of the programming procedure.

The subsequent table shows the general structure of the menu.

Detailed descriptions of all parameters will follow in section 5.2.

4.1. Overview of Basic Parameters

DX345

DX346

DX347

DX348

Type (Application Mode)

Input Characteristics

Brightness

Code

Linearization Mode *)

Analog Output Mode

Preselection Mode 1

Serial Unit Number

Analog Offset

Preselection Mode 2

Serial Format

Analog Gain

Hysteresis 1

Serial Baud Rate

Hysteresis 2

*) Appears only with Modes "RPM" and "Count"