User manual

IX34510b_e.doc / Mrz-13 Page 11 / 43
3. The Operator Menu
The menu provides one section with “Basic Parameters” and another section with “Operational
Parameters”. On the display you will only find those parameters which have been enabled by
the basic settings. E.g. when the Linearisation Functions have been disabled in the basic set-
up, the associated linearization parameters will also not appear in the parameter menu.
All parameters, as good as possible, are designated by text fragments. Even though the
possibilities of forming texts are very limited with a 7-segment display, this method has proved
to be most suitable for simplification of the programming procedure.
The subsequent table shows the general structure of the whole menu only.
Detailed descriptions of all parameters will follow in section 4.
3.1. Overview of Basic Parameters
IX 345
IX 346
IX 347
IX 348
SSI_Mode SSI_Mode SSI_Mode SSI_Mode
SSI_Bits SSI_Bits SSI_Bits SSI_Bits
SSI_Format SSI_Format SSI_Format SSI_Format
SSI_Baud Rate SSI_Baud Rate SSI_Baud Rate SSI_Baud Rate
SSI_Test SSI_Test SSI_Test SSI_Test
Characteristics Characteristics Characteristics Characteristics
Brightness Brightness Brightness Brightness
Code Locking Code Locking Code Locking Code Locking
Linearization Mode Linearization Mode Linearization Mode Linearization Mode
Analogue Characteristics Preselection_Mode 1 Ser_Unit_Nr
Analogue Offset Preselection_Mode 2 Ser_Format
Analogue Gain Hysteresis 1 Ser_Baudrate
Hysteresis 2