Datasheet

Uz210_02c_oi_e.doc / Dez-15 Page 18 / 27
5.4. Encoder Setting (Incremental Output)
No.
Parameter Description
Range
Default
Ser.
025
POS Low Value: Beginning of the position count where
the analogue input equals to „Analogue Low Value“
±100 000 000
(increments)
0
C4
026
POS High Value: End of the position count where
the analogue input equals to „Analogue High Value“
±100 000 000
(increments)
10 000
C5
027
FRE Low Value: Start value of the frequency where
the analogue input equals to „Analogue Low Value“
± 1 000 000.00
(Hz)
-1000.00
C6
028
FRE High Value: End value of the frequency where
the analogue input equals to „Analogue High Value“
± 1 000 000.00
(Hz)
+1000.00
C7
029
Reserved, no function
030
Reserved, no function
5.5. Command Setting (Control Inputs)
No.
Parameter Description
Range
Default
Ser.
031
Input 1 Config: Switching characteristics of input „Cont1“
0: Function active with static LOW level
1: Function active with static HIGH level
0, 1
0
D0
032
Input 1 Function: Function of input „Cont 1“
0: no function assigned
1: Function „Set“. Forces the analogue input temporary
to the fixed value according to the setting of
[Analogue Set Value] (see parameter Nr. 013)
2: Function „Inhibit“. Disables temporary all changing
at the analog input and freeze the last value
3: Function „DOWN“. Down-function (decrease value)
with motorized potentiometer applications
4: Funktion „UP“. Up-function (increase value) with
motorized potentiometer applications
5: Function „Z-Reference“. Assigns a static Reset
function for the marker impulse counter *)
6: Function „Print“. The input will trigger a serial
transmission of the specified measuring value.
0 - 6
0
D1
033
Input 2 Config: see „Input 1 Config“
0, 1
0
D2
034
Input 2 Function: see „Input 1 Function“
0 - 6
0
D3
035
Input 3 Config: see „Input 1 Config“
0, 1
0
D4
036
Input 3 Function: see „Input 1 Function“
0 - 6
0
D5
037
Input 4 Config: see „Input 1 Config“
0, 1
0
D6
038
Input 4 Function: see „Input 1 Function“
0 - 6
0
D7
039
Reserved, no function
040
Reserved, no function
*) Function only suitable for slow and purely static Reset (e.g. for index referencing in standstill).
For dynamic requirements please refer to parameter 005 [HW-Z-Reference]