SDS
Protective
Equipment:
*
See www.paint.org/hmis or call the NPCA at 1 (202) 462-6272 for more information on this current rating system.
4. FIRST AID MEASURES
Eyes:
Immediately flush eyes gently with plenty of water for at least 15 minutes while holding eyelids apart. If symptoms persist or there
is visual difficulty, seek medical attention.
Skin Contact:
In case of contact, immediately wash contaminated area with plenty of water for at least 15 minutes.
Seek medical attention if
symptoms persist.
Wash clothing before reuse.
Ingestion:
Contact a physician, medical facility, or poison control center immediately.
Inhalation:
Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
Keep the victim warm and
quiet.
Seek immediate medical attention.
Continue your efforts until help arrives or the victim starts to breathe on his own. Do not
leave victim alone.
NOTES TO PHYSICIAN:
No additional first aid information available.
Preexisting disorders of the following organs (or organ systems) may be aggravated by exposure to this
material:
lung (for example, asthma-like conditions);
liver;
kidney;
skin;
blood forming system;
5. FIRE FIGHTING MEASURES
Fire and/or Explosion Hazards:
This product contains a component(s) that is considered a flammable liquid, which has vapors that are heavier
than air and may travel along the ground or be moved by ventilation and ignited by heat, pilot lights, or other
flames and ignition sources at locations distant from the material's handling point.
Fire Fighting Instructions:
Use alcohol foam, water fog, dry chemical, or CO2.
Water is generally not effective and may spread fire; however,
water spray may be used from a safe distance to cool closed containers and protect surrounding area.
6. ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED:
Avoid run-off into storm sewers and ditches which may lead to natural waterways.
Remove all sources of ignition.
Wear appropriate personal protective
equipment (PPE).
Stop or reduce discharge if it can be done safely.
Ventilate contaminated area.
If runoff occurs, notify authorities as required.
Clean up
with absorbent material.
Place absorbent materials into container and close it tightly. Dispose of container properly.
7. HANDLING AND STORAGE
Handling:
If ventilation is not sufficient, wear proper respiratory equipment.
Do not use near ignition sources.
Avoid prolonged or repeated breathing
of vapor.
Avoid prolonged or repeated contact with skin.
Do not store containers in excessive heat or direct sunlight.
Protect container
against physical damage.
Use with adequate ventilation.
Storage:
Keep container tightly closed when not in use.
Store in a cool, dry, well ventilated area away from all sources of ignition.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering Controls:
Ventilation should be adequate to prevent exposures above the limits indicated below in this section of the SDS (from
known, suspected or apparent adverse effects).
Local exhaust should be used in areas where exposure limits may be
exceeded.
Eye Protection:
Wear chemically resistant safety glasses with side shields when handling this product. Wear additional eye protection such as
chemical splash goggles and/or face shield when the possibility exists for eye contact with splashing or spraying liquid or
airborne material. Have an eye wash station available.
Skin Protection:
The use of chemically resistant gloves is recommended if there is any possibility of prolonged or repeated liquid contact with
skin.
Respiratory Protection:
Use NIOSH approved respirator where there is likelihood of inhalation of the product mist, spray or aerosol.
A supplied air
respirator should be used if ventilation is not sufficient to maintain exposure limits.
COMPONENT
CAS #
ACGIH TLV
OSHA PEL
OTHER
Glycol ether
111-76-2
20 ppm [skin]
Not established
Not established
2-propanone
67-64-1
500 ppm TWA
Not established
Not established
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State:
Bulk liquid
Lower Flammability Limit (%):
0.9
Appearance:
Clear to hazy.
Upper
Flammability Limit (%):
13
Odor:
Citrus
Vapor Pressure (PSIG @ 70
°
F):
Not determined
Odor Threshold:
Mild
Vapor Density [air = 1]:
> 1
pH:
6.0 - 8.0
Relative Density (H2O=1):
0.99
Melting/Freezing Point (°F):
No data available
Solubility in Water:
Complete; 100%
Boiling
Point (°F):
No data available
Partial Co
efficient: n-
octanol/water:
No data available
Flash Point (
°
F PMCC):
<50
Autoignition Temperature (°F):
Not applicable
Evaporation Rate:
Not determined
Decomposition Temperature
(°F)
:
No data available
Flammability (solid, gas):
No data available
Viscosity
, dynamic (cSt):
No data available
Percent VOCs (%):
1-20
Stoner Incorporated 41136
PAGE 2