User Manual-for Windows

INSTALLING THE 828MK3 HARDWARE
26
A TYPICAL 828MK3 SETUP
Here is a typical 828mk3 studio setup. This rig can
be operated without an external mixer. All mixing
and processing can be done in the computer with
audio software. During recording, you can use the
828mk3’s CueMix FX no-latency monitoring to
listen to what you are recording via the main outs,
headphone outs, or any other output pair. You can
control monitoring either from the front panel or
from the included CueMix FX software. The two
front-panel guitar/mic inputs can be routed to
outboard effects processors, such as a compressor,
EQ or reverb, via the rear panel sends.
PC
S/PDIF
DAT deck
quarter-inch
analog outs
synthesizer
monitors
guitar
quarter-inch analog outs
synths, samplers, effects units, etc.
sends to
FX unit
(in rack
below)
Figure 4-12: A typical 828mk3 studio setup.
headphones
other outputs (stage
monitors, surround
monitors, etc.)
MIDI IN/OUT
foot
switch
828mk3
front panel
828mk3
back panel
Compressor, reverb or
other outboard gear
mic
FireWire or USB
MOTU 8pre and/or
other optical devices
8-channel
ADAT optical
headphones
send
returns
to send returns
!828mk3 Hyb Manual/Win Page 26 Monday, March 28, 2011 6:11 PM