User Manual-for Windows

INSTALLING THE 828MK3 HARDWARE
29
SYNCING TO SMPTE TIMECODE
The 828mk3 system can resolve directly to SMPTE
timecode. It can also generate timecode and word
clock, under its own clock or while slaving to
timecode. Therefore, the 828mk3 can act both as
an audio interface and as a digital audio
synchronizer to which you can slave other digital
audio devices. You can use the 828mk3 to slave
your audio software to SMPTE as well, via sample-
accurate sync (if your host software supports it).
Other digital audio device
slaved to the 828mk3
Figure 4-17: Connections for synchronizing
the 828mk3 directly to SMPTE timecode.
Choose SMPTE as the clock source in MOTU
Audio Console. This setting can also be made in
the MOTU SMPTE Console (shown below).
SMPTE timecode
source
audio cable bearing LTC
(Longitudinal timecode)
FireWire or USB cable
Launch the MOTU SMPTE Console and specify the SMPTE Source,
which is the interface receiving the SMPTE timecode. Also, confirm
that the Clock Source/Address is SMPTE/SMPTE. For details about the
other settings, see chapter 10, “MOTU SMPTE Console” (page 111).
video
cable
audio
cable
SMPTE
out
Word
Out
Windows computer running Cubase or
other sample-accurate ASIO software
In Cubase, go to the Synchronization window and
choose ASIO Audio Device as the Timecode Base.
828mk3 interface
SMPTE IN
quarter-inch jack
When lockup is achieved, the
LOCK/TACH light glows.
Use this setup if you have:
✓ A SMPTE timecode source, such as a multitrack tape deck.
✓
An 828mk3 by itself, OR with another slaved device (such as a
digital mixer).
✓ Host software that supports sample-accurate sync (such as
Cubase or Nuendo).
This setup provides:
✓ Continuous sync to SMPTE timecode.
✓ Sub-frame timing accuracy.
✓ Transport control from the SMPTE timecode source.
!828mk3 Hyb Manual/Win Page 29 Monday, March 28, 2011 6:11 PM