User Manual-for Windows

FRONT PANEL OPERATION
54
REVERB — these are the reverb send and return
controls for the bus master fader. Access them with
the PARAMETER knob. Note: if the reverb
processor is currently disabled, reverb is displayed
in parentheses. If you are running the 896mk3 at
88.2 kHz or higher, the Reverb processor is
disabled, and therefore the REVERB setting does
not appear in the LCD as an option.
■ Individual channels — once you scroll past
MASTER and REVERB, the PAGE knob then
scrolls through all available inputs for the mix bus.
Once you choose an input, access its channel
settings using the PARAM knob and VALUE knob.
Summary of Mix menu settings
For a summary of Mix menu settings, see “Mixes
menu” on page 56.
The REVERB menu
Push the CHANNEL button repeatedly until you
see “REVERB” in the channel section of the LCD
(Figure 6-12). This is similar to accessing the
Reverb tab in CueMix FX (“The Reverb tab” on
page 94).
☛ The REVERB processor is not available at
sample rates above 48 kHz. Therefore, when the
896mk3 is operating at 88.2 kHz or higher, the
REVER menu does not appear in the LCD.
Figure 6-12: The REVERB menu.
Working with reverb settings in the LCD
Once you’ve selected the REVERB menu, you can
access all settings using the PARAMETER and
VALUE knobs. The PAGE knob is not needed and
is therefore disabled when editing reverb settings.
Summary of Reverb menu settings
For a summary of Reverb menu settings, see
“Reverb menu” on page 56.
Access individual
parameters here,
such as reverb time.
Change the value of
the current parame-
ter here.
896mk3 Hybrid book Page 54 Friday, August 19, 2011 2:04 PM