User Manual

FRONT PANEL PRESETS
52
correctly, and you can then focus your efforts on other
possible causes, such as bad MIDI cables, volume settings,
etc.
Use this troubleshooting technique if you cannot
successfully record data into your sequencer on the
computer.
Merge Some
The Merge Some preset is similar to the Merge All preset,
except that it divides the inputs into two groups: inputs 1-
4 (1-2 on the micro express) are routed to the computer
only, while inputs 5-8 (3-4 on the micro express) are
routed directly to all outputs (but not the computer).
Dual Split
The Dual Split preset is similar to the Live Keyboards
preset, except that it splits the interface into two sets of
inputs and outputs.
For the micro express, i
nput 1 is routed to outputs 1-3.
Input 3 is routed to outputs 4-6.
For the Express XT, i
nput 1 is routed to outputs 1-4. Input
5 is routed to outputs 5-8.
MIDI Machine/for the Express XT
This preset provides MIDI data, time code, and MIDI
Machine Control settings for using MIDI Machine
Control between devices without a computer.
Inputs 1-4 are reserved for non-MMC devices being
routed to outputs 1-5, as well as the computer.
Input 5 is also routed to the computer but not to any of the
MIDI outputs.
MIDI outputs 6, 7 and 8 are reserved for MIDI Machine
devices, as these ports are programmed to receive MIDI
Time Code and MMC transport commands from the
MIDI Express XT.
MIDI inputs 6, 7 and 8 are intended for MMC controller
devices, and they are each programmed slightly differently
to accommodate three different scenarios. Input 6 routes
!USB Interfaces Manual Book Page 52 Tuesday, August 16, 2011 11:21 AM