User Manual

MOTU PRO AUDIO CONTROL WEB APP
20
AUX BUS CHANNEL STRIPS
Aux buses can be used to create sub-mixes. An
aux bus can be assigned to any output in the
Routing grid (page 15).
To access an Aux bus channel strip, go to the
Mixing tab (page 16), reveal the side bar (item #3
on page 16), and then show the aux buses you
want in the Mixer Outputs section (29).
To show and hide the four-band EQ section of the
channel strip, use the Controls section of the side
bar (item #3 in the Mixing tab on page 16).
1. A stereo aux bus.
2. A mono aux bus.
3. Click this dot to toggle an aux bus between
mono and stereo.
4. The four-band parametric EQ module for Aux
buses operates the same as described for
input channels (items 10 and 11 on page 18),
including High and Low Shelf filter options.
5. The thumbnail EQ Graph displays the
currently enabled EQ filters, if any. Click it to
open the full-size, editable EQ Graph
(Figure 9-4 on page 73).
6. Aux bus solo and mute.
7. Aux bus master fader.
8. Click to type specific value manually.
9. Click to route the talkback mic to the aux bus
output.
10. Click the dB scale numbers to make the fader
jump exactly to that level. Click and drag
horizontally to jump consecutive faders to the
same level.
11. A disabled EQ band.
12. Use these menus (hardware settings, output
assignment, and presets) in a similar fashion
as described for the Main Out bus (items 3-5
on page 19).
1
3
11
4
6
7
8
10
2
12
5
9