User Manual

FRONT PANEL OPERATION
61
Figure 7-8: Mixer setup for the talkback mic.
Talkback settings
The talkback settings (Figure 7-8) can be accessed
by enabling the Legend in the Controls panel of
the mixer.
Ta l k
Press and hold the Talk button (Figure 7-8) to
engage the talkback mic. This is the same as
pressing the TALK button on the front panel of the
828es (item #10 on page 9).
Sticky
When Sticky is engaged (Figure 7-8), the Talk
button remains engaged when you click it, until
you click it again to disengage, so you don’t have to
hold it down while speaking. This setting also
affects the TALK button on the front panel of the
828es (item #10 on page 9).
Talkback
settings
Talkback
source
Talkback
output
Legend
Talkback
section
Figure 7-9: Basic routing for the built-in talkback mic. In this example, the built-in talkback mic is routed to input 1 of the mixer. Aux bus
1-2 is assigned to analog outs 7-8, which are being used to route the signal to speakers in the room where the musicians are located.
Step 1
Step 2