User Manual

FRONT PANEL OPERATION
47
PUSH-BUTTON ROTARY ENCODERS
All of the knobs shown in Figure 6-3 are push-
button digital rotary encoders. In many cases, you
can either push the knob or turn it to make a
setting or toggle the LCD display (depending on
the encoder and setting).
MULTI-FUNCTION LCD DISPLAY
The LCD provides access to the many 828x
settings, as well as visual feedback of the current
parameter being modified.
Parameter “zooming
For many settings, the LCD temporarily “zooms
in to display a long-throw meter and an alpha-
numeric display to give you precise, real-time
feedback as you adjust the setting. For example, if
you change the headphone volume, the LCD will
display a level meter and gain reduction reading
that updates as you turn the volume knob. After a
brief time-out, the display returns to its previous
state before you turned the volume knob.
Figure 6-4: The LCD provides feedback as you adjust volume.
Three global menus
Push the PARAM knob to cycle the LCD among
three global menus, described in the rest of this
chapter:
828x SETUP
AUDIO (settings)
CUEMIX (mixer)
Figure 6-3: The 828x front panel controls.
The LCD is divided into four
sections that correspond to the
four knobs to the left.
Push the PARAM knob to cycle
among three global menus:
CueMix (mixer), AUDIO
(settings) and 828x SETUP.
When viewing CueMix settings
in the LCD, push the CHANNEL
knob to cycle among four main
mixer menus: MIX, IN (inputs),
OUT (outputs) and REVERB.
Turn it to choose a channel.
Turn the PAGE knob to view settings for
each channel. Push it to jump to the
next section or back to the beginning.
Turn and/or push the
VALUE knob to adjust
the current setting.