User Manual

REDUCING MONITORING LATENCY

Follow the directions below in the section that

applies to you.

Controlling CueMix DSP from within AudioDesk

or Digital Performer

To turn on CueMix DSP in AudioDesk and Digital

Performer:

1 From the Setup menu, choose Conﬁgure Audio

System>Input Monitoring Mode.

2 Choose the Direct hardware playthrough option,

as shown below in Figure 10-7.

3 From the Studio menu, choose Audio Monitor,

and enable Audio Patch Thru (the button with the

headphone icon on it).

Figure 10-7: Enabling CueMix DSP in AudioDesk or Digital Performer.

Note: the ‘Only during recording...’ and ‘Always’ options are for

AudioDesk 2 and DP4 only. DP5 has expanded input monitoring

features. Consult your DP5 documentation.

Once enabled, CueMix DSP monitoring is tied

with Digital Performer or AudioDesk’s Audio Patch

Thru feature: when you record-enable a track, the

track’s input is routed directly to its output (via

CueMix DSP in the 8pre hardware). For example, if

you record-enable a track called guitar in your DP

or AudioDesk project, and its audio input

assignment is Analog in 2, and its audio output

assignment is channels 7-8, CueMix DSP no-

latency hardware monitoring will automatically be

set up from analog in 2 to outputs 7-8.

Controlling CueMix DSP from within other

software

Consult the manual for your software.

!8pre Manual/Mac Page 50 Tuesday, October 12, 2010 5:52 PM