User Manual-Mac

CUBASE, NUENDO AND OTHER ASIO SOFTWARE
93
ASSIGNING OUTPUTS
As shown earlier in Figure 9-2 on page 90, any
banks that you have enabled in the MOTU PCI
Audio Console will be available in Cubase or
Nuendo as outputs. In Cubase VST, these outputs
appear in the VST Master Mixer window as output
assignments for the master fader and busses, as
shown below in Figure 9-7.In Nuendo, they appear
in the VST Outputs window.
CHANGING PCI-424 SETTINGS
To change the PCI-424 settings at any time, run the
MOTU PCI Audio Console. See “The Launch
button” on page 91 for details. In Nuendo, go to the
Device Setup window and click the ASIO Control
Panel button, as shown in Figure 9-3 on page 90.
In Cubase VST, use the output buttons at the bottom of each channel strip, including the master fader, to assign PCI-424
outputs to busses. You can then assign channels in the VST Master Mixer window to each bus as desired.
Figure 9-7: Working with PCI-424 outputs in Nuendo or Cubase.
In Nuendo, access the PCI-424 outputs via the busses in the VST Outputs window.