User Manual-Windows

CUBASE, NUENDO AND OTHER ASIO SOFTWARE
78
ASSIGNING OUTPUTS
As shown earlier in Figure 7-1 on page 75, any
banks that you have enabled in the MOTU PCI
Audio Console will be available in Cubase or
Nuendo as outputs. In Cubase VST, these outputs
appear in the VST Master Mixer window as output
assignments for the master fader and busses, as
shown below in Figure 7-6. In NuendoCubase SX,
they appear in the VST Outputs window.
CHANGING PCI-424 SETTINGS
To change the PCI-424 settings at any time, go to
the Audio System Setup window in Cubase VST or
the Device Setup window in Nuendo or Cubase SX
and click the ASIO Control Panel button, as shown
in Figure 7-2 on page 76.
In Cubase VST, use the output buttons at the bottom of each channel strip, including the master fader, to assign
PCI-424 outputs to busses. You can then assign channels in the VST Master Mixer window to each bus as desired.
Figure 7-6: Working with PCI-424 outputs in Nuendo or Cubase.
In Nuendo or Cubase SX, access the PCI-424 outputs via the busses in the VST Outputs window.