User Manual

MOTU AVB CONTROL WEB APP
12
DEVICE TAB
10
6
7
12
13
5
4
3
2
1
8
17
1. If you have two or more MOTU AVB
interfaces, the Device list lets you
choose the one you are currently
controlling with the web app.
2. The Aux Mixing tab lets you view
each Aux bus in the mixer, one at a
time.
3. The Mixing tab gives you access to
the mixing and DSP in the interface.
4. The Routing tab displays a grid
matrix, where you can make direct
connections between inputs and
outputs, your computer, the mixer,
and network audio streams, if
networked interfaces are connected.
5. The Device tab has settings for the
hardware itself, such as analog input
and output trim.
6. Expands and collapses the sidebar.
7. Lets you create, save, recall and
manage presets for the Stage-B16.
These presets capture and recall the
complete state of the device (all
settings in all tabs).
8. Choose the number of audio
channels you want to use over USB,
which depends on the sample rate.
9. Choose the desired sample rate.
10. Click to rename the interface. To
restore the default name, delete the
current name.
11. The Quick Setup button prompts
factory presets used to configure
your interface for a specific applica-
tion. See chapter 5, “Presets”
(page 45).
12. Click this device ID button to identify
the unit you are currently viewing
and controlling with the web app
software. The front panel on the
hardware itself will flash LEDs, and
its name will also flash in the Device
list (1).
13. If an update is available for your
device, and the computer you are
viewing it from is connected to the
internet, you’ll be notified here. Click
More Info to learn what’s new and
start the update process. Firmware
updating requires a network
connection. See Appendix D,
“Updating Firmware” page (79).
14. Choose the clock source from the
Clock Mode menu. Your MOTU device
will resolve its digital clock to this
master source.
15. The Clock Status icon indicates that
the current device (1) is successfully
resolved to its chosen Clock Mode
source (14). If it cannot lock for some
reason, this icon flashes red. Check
your chosen clock source, cables, etc.
16. If you have multiple MOTU AVB
interfaces, one of them may serve as
a master clock source for the
network. Click the Become Clock
Master button to choose the current
interface (1) as the master clock
source.
17. The Input Settings section provides
preamp gain settings for the 16 mic
inputs, plus phase invert, 48V
phantom power and -20 dB pad.
18. The Output Settings section lets you
adjust the trim for the analog
outputs. The Phones output
provides full volume control. Analog
outputs provide calibration control
(-24 to 0 dB).
16
15
11
14
18
9