User Manual

BOUNCE TO DISK
943
Figure 84-19: Multi Bounce from multiple DP documents.
Remove
If you are viewing bounce settings from multiple
DP documents in the list (Figure 84-19), use the
Remove button to eliminate a file’s bounce settings
from the list. Just click one of the file’s bounce
settings to highlight it and click Remove.
OK/Cancel
Click OK to initiate the multi bounce operation, or
click Cancel to abort. During the multi-bounce
operation, each file will open (if necessary), and
you’ll see a status panel that gives you a running
update of the progress of the operation:
Figure 84-20: Multi Bounce status panel.
Multi bounce summary report
When a multi bounce operation is completed, a
summary window reports the success of each
bounce operation, or errors, if any.
Figure 84-21: Multi Bounce summary report.
Initiating Multi Bounce when no DP document
is current open
The Multi Bounce command can be chosen even
when no DP project file is currently open. This
allows you to initiate a multi bounce operation
without first opening a DP document. With no DP
document currently open, choose File menu>
Bounce Settings> Multi Bounce. The Multi Bounce
window appears (Figure 84-18) with no items yet
listed.
Click the Add button to load in the desired bounce
settings from any number of DP documents. When
you are finished, the list will show the bounce
settings for each document, as demonstrated
earlier in Figure 84-19. Shift-click and/or
Command/Ctrl-click to select the bounce settings
you wish to include in the batch operation, and
then click OK.
Edit Bounce Again Settings
Choose Edit Bounce Again Settings (Figure 84-17
on page 942) to rename, delete or assign a key
binding to the saved bounce settings in the current
DP project.