Instruction manual

USING THE FRONT PANEL LCD
114
The knob output assignment window works in the
same fashion as the pedal output assignment
window described in the section “PEDAL
OUTPUT ASSIGNMENT” on page 111. Please
refer to that section for details.
☛ Note: similarly to pedals, knob output cannot
be assigned directly to an output cable. Instead, it
must be assigned to an input cable with which it
gets merged.
MIDI ROUTING
Use the WINDOW knob to go to the MIDI
ROUTING window. Use the CURSOR, SELECT,
and VALUE knobs to make cable routings as
follows:
Route by cables
Use the SELECT knob to choose an input cable.
Use the VALUE knob to select an output to which
to route the input. Once you have made your input
to output cable choices, press YES/NO to make (or
break) the connection. (For cable designations, see
“Getting familiar with the LCD conventions” on
page 104.)
Route by channel
Use the SELECT knob to choose an input cable.
Use the CURSOR and VALUE knobs to select the
input cable and channel that you want to route to
an output cable. (The input and output channel are
the same.) Once you have made your input to
output cable choices, press YES/NO to make (or
break) the connection. (For cable designations, see
“Getting familiar with the LCD conventions” on
page 104.)
MUTING MIDI DATA
Use the WINDOW knob to go to the MUTE MIDI
DATA window. Make the muting settings with the
CURSOR and VALUE knobs as follows:
MIDI CHANNEL MAP
Use the WINDOW knob to go to the MIDI
CHANNEL MAP window. Make the mapping
settings with the CURSOR and VALUE knobs as
follows:
Input Channel Remap
Use the SELECT knob to choose an input cable.
Use the CURSOR and VALUE knobs to select the
source and destination channels. (For cable
designations, see “Getting familiar with the LCD
conventions” on page 104.)
ROUTE BY CABLES
D In_1>Out 1 NE
ROUTE BY CHANNEL
D In_1CH 1 OUT 1 N
IN 1 CH 1
CONTROLLERS N
Input or output
Type of data to be muted
Press YES/NO
button to mute (Y)
or unmute (N) the
Cable
Channel
(displays dashes for non-
channel specific data)
IN CHANNEL REMAP
D IN _1CH 7 TO 1 E
!USB Interfaces Manual Book Page 114 Tuesday, October 10, 2000 12:43 PM