User Manual

HARDWARE OPERATION
40
Output volume control
To control volume, push the desired output
(MAIN, PHONES, or LINE OUT). The button
illuminates green. Turn the knob to adjust the
output volume.
Input trim
To control input trim, push the desired input
(MIC, GUITAR, or LINE IN). The button
illuminates green. Turn the knob to adjust the
input trim.
Input bus volume
To control input bus level (CueMix input fader),
push the output bus (MAIN, PHONES, LINE
OUT) and the desired input (MIC, GUITAR, or
LINE IN) at the same time. Both the input and
output buttons illuminate green. The input button
illuminates green. Turn the knob to adjust the bus
volume.
Muting/unmuting
To mute or unmute an output, push the desired
output (MAIN, PHONES, or LINE OUT) to select
it. The button illuminates green. Push the knob to
mute or unmute the output. While muted, the
button blinks.
To mute or unmute input bus volume (CueMix
input fader), push the output bus (MAIN,
PHONES, LINE OUT) and the desired input
(MIC, GUITAR, or LINE IN) at the same time.
Both the input and output buttons illuminate
green. Push the knob once to mute or unmute the
input on that bus. When muted, the button blinks;
unmuted it stops blinking.
Pad and 48V phantom power
To toggle a -20dB pad, push MIC 1 or MIC 2 and
then push the knob once. The yellow pad (P) LED
turns on or off.
To toggle 48V phantom power, push MIC 1 or
MIC 2 and hold down the knob. The red phantom
power (V) LED turns on or off.
Lockout mode
Hold the METERS button down for 2 seconds to
enter Lockout mode. In this mode, the knob and
buttons are temporarily disabled, to prevent
unwanted changes to any Track16 settings. While
in lockout mode, the METERS button blinks.
Hold the METERS button for 2 seconds again to
exit lockout mode.
Button LED color schemes
The Track16 button LEDs have the ability to
display several different color combinations. From
the factory, the currently selected button is green
and the others are amber. But you can choose other
color combinations, if you like.
To change the button LED color scheme:
1 Hold the METERS button down for 2 seconds to
enter Lockout mode.
The METERS button blinks.
2 Press the METERS button repeatedly to cycle
among the different LED color schemes.
3 When you have chosen the desired scheme, hold
the METERS button again for 2 seconds to exit
Lockout mode.
You can change the LED color scheme at any time.
FACTORY SETTINGS
To restore these factory settings, hold down the
MAIN and LINE OUT buttons for 2 seconds:
■ The MAIN button is active (green) and,
therefore, the knob controls main out volume.
■ The OUTPUT METERs button is inactive, and
therefore, the meters display levels for MIC IN,
GUITAR IN, and LINE IN.
■ On the mic inputs, 48V phantom power and
-20 dB pad are off.