User guide

CLOCKWORKS
30
Save Configuration
The Save Configuration menu item saves all the current
MOTU interface settings in ClockWorks as a document on
disk. You can restore the settings by opening it with the
Load Configuration command.
Refresh
ClockWorks always reflects the current state of your
MOTU interface. However, if at any time you suspect that
the windows in ClockWorks don’t accurately reflect what’s
going on in the hardware for some reason, choose Refresh
from the File menu. ClockWorks will be updated to reflect
the current state of the hardware.
How ClockWorks interacts with the hardware
Changes you make in ClockWorks are immediately
reflected in the hardware. Likewise, when you select a
preset from the front panel, your MOTU interface updates
ClockWorks, as long as the software is the currently active
application. This is a convenient way to run through your
user presets and inspect each one’s settings in
ClockWorks. If ClockWorks is not the active application
on the computer, a system exclusive message is sent to
whatever application is currently active. If this application
is recording incoming MIDI, these sysex messages get
recorded as well.
Reset to Factory Settings
This menu item restores the factory default settings in the
interface.
THE CLOCKWORKS WINDOW
ClockWorks appears as a single window for each MOTU
interface, as shown in Figure 5-1 on page 28. Click each
tab to view the settings within the tab.
ROM version display
The ROM version of the currently selected USB MIDI
device appears in the transport section of the window, as
shown in Figure 5-1 on page 28.
!USB Interfaces Manual Book Page 30 Tuesday, August 16, 2011 11:21 AM