Operation Manual

7
- If the power cable or the plug are damaged,
do not use the appliance. To avoid any risk,
these must be replaced by an approved
Moulinex service centre (see list in service
booklet).
- For your own safety, use only Moulinex
accessories and spare parts which are
suitable for your appliance.
- Install your appliance on a stable, flat work
surface, temperature-resistant and well away
from any source of heat and any risk of water
splashes.
- Never turn on the appliance without first
putting water into the tank (A).
- For reasons of hygiene, only use the
appliance for heating or keeping warm
baby food.
Using your appliance
Important notes:
- Baby food heats up at rates which vary,
depending on its consistency: milk according
to the richness of its mixture, and pots of
food depending on how substantial they are.
- You will soon find out for yourself at what
temperature to set the pot warmer to prepare
a hot meal for your child.
- Refer to the times recommend by the
manufacturers of the baby foods, but in all
cases, always check, by dropping a little
milk or baby food onto the back of your
hand, that the milk or food is not too hot,
so that you avoid the risk of burning your
baby’s mouth.
. BOTTLE WARMING FUNCTION
- Place the bottle in the tank (A) and then fill it
with water up to 1 cm from the top.
- Using the thermostat button (C), select a
setting between 1 and 5, without exceeding
the setting «
».
- The control indicator light (B) will come on.
- After 5 - 10 minutes, the control light (B) will
go out: the bottle is now ready.
- Shake the bottle and always check, by
dropping some milk onto the back of your
hand, that the milk is not too hot.
- For small quantities, never use setting 5
on the thermostat button (C).
. POT WARMING FUNCTION
Important: always remove the lid of the pot
of baby food before placing it in the tank.
- Place the tongs (E) around the pot and put it
into the tank (A).
- Fill the tank with water.
- Using the thermostat button (C), select a
setting between 5 and 8.
- The control indicator light (B) will come on.
- Remember to stir the contents of the pot from
time to time so that there is an even
distribution of heat during preparation.
- After 15 - 20 minutes, the control light (B)
will go out: the pot is now ready.
- After stirring the contents, always check
by tasting that the food is not too hot, so
that you avoid the risk of burning your
baby.
- For small quantities, never use settings
7 and 8 on the thermostat button (C).
If you find that the milk or food are too
hot :
- Leave the bottle or pot to stand for a short
period of time to cool. Check again for
temperature before attempting to feed your
baby.
. KEEPING-WARM FUNCTION
- Do not leave bottle or baby food pot to
heat for more than one hour.
You can also keep a bottle or pot of food warm
when you have just heated it up.
- Replace the bottle or pot in the tank (A),
making sure that there is still plenty of water
- Adjust the thermostat button (C) to a setting
between 1 and 3.
. USE WITH THE CIGARETTE-LIGHTER ADAPTER
(F) (DEPENDING ON MODEL)
You can also use your pot warmer in the car
with the cigarette-lighter adapter (F)
- Never use it while the vehicle is moving
as you risk burning yourself.
- Fit the adapter (F) to the power cable and
plug it into the cigarette lighter socket in your
vehicle.
The appliance will now work exactly as
described above. However, in this case,
heating time is slightly longer. To heat the
feeding bottles quicker, turn the button to the
“
” position.
Cleaning
- Unplug the appliance and allow it to cool.
- Never immerse the appliance in water and
never wash it under running water.